Powder Spraying and Marking Device

Power Spraying and Marking Device is applicable to digital-control cutting machine of different series. It has width of the line is 0.5mm, which is adjustable. In addition of this, melts zinc powder inside storage tank with flame and spray it onto the steel plate according to design, then along the zinc powder line cutting machine conducts cutting with digital-control cutting torch.

Instructions to be Followed

• The Power Spraying and Marking Device has 4 gas inlet channels among which 3 are for oxygen, 1 for Fuel gas. Two outermost channels, one is for preheat oxygen, the other is for Fuel gas; the middle one is for cutting oxygen; by which it is for powder spray.
• Firstly, screw off knurled nut, put zinc powder into storage tank and screw on the nut.
• Secondly, ignite powder spray device, adjust cutting oxygen, open the value of powder spray gas channel, then zinc powder will be automatically sprayed onto the plane.